LED

Step 1: Making the LED lights dance to your music

Objective here is to use the A/D converter on Arduino to read input sound and light up a set LEDs to reflect the level of the sounds volume. The LEDs are controlled from Digital pins 3, 4, 5,6.  They are turned on based on what the level of input is from the Analog 0 pin, which is connected to the headphone jack.

 

Parts:

1x Arduino

4x LEDs

4x 390 ohm resistors

1x 10k trimpot

1x Headphone jack

1x 10uF Capacitor

 

Step one layout

 

 

// LED light dance

 

#define soundpin A0               //  reads the power from the light sensor from Analog input 0

#define LED1 3                    //  4 Leds LED's on Digital output pins 3,4,5,6

#define LED2 4

#define LED3 5

#define LED4 6

 

int sound;

 

void setup()

{

  // initialize the serial communications:

  Serial.begin(9600);

 

  // Provide power by using the analog inputs as normal digital pins.  

  pinMode(soundpin, INPUT);

  pinMode(LED1, OUTPUT);

  pinMode(LED2, OUTPUT);

  pinMode(LED3, OUTPUT);

  pinMode(LED4, OUTPUT);

}

void loop()

{

      sound=analogRead(soundpin);   // this samples the sound constantly

      if((sound)>200)

        {

             digitalWrite(LED1,HIGH);   // set the LEDs on

             digitalWrite(LED2,HIGH);

             digitalWrite(LED3,HIGH);

             digitalWrite(LED4,HIGH);

        }  

        else if((sound)>150)

        {

             digitalWrite(LED1,HIGH);   // set the LED on

             digitalWrite(LED2,HIGH);

             digitalWrite(LED3,HIGH);

             digitalWrite(LED4,LOW);   // set the LED off

        }

        else if(sound>100)

        {

             digitalWrite(LED1,HIGH);   // set the LED on

             digitalWrite(LED2,HIGH);

             digitalWrite(LED3,LOW);   // set the LED off

             digitalWrite(LED4,LOW);

        }

         else if(sound>50)

        {

             digitalWrite(LED1,HIGH);   // set the LED on

             digitalWrite(LED2,LOW);   // set the LED off

             digitalWrite(LED3,LOW);

             digitalWrite(LED4,LOW);

        }

         else

        {

             digitalWrite(LED1,LOW);   // set the LEDs off

             digitalWrite(LED2,LOW);

             digitalWrite(LED3,LOW);

             digitalWrite(LED4,LOW);

        }

       

     Serial.println(soundpin);              //output for serial monitor

 

     delay(25);                                   // And a shot delay

}

 

 

 

Links to projects that helped with getting this project working.

http://www.instructables.com/id/VU-Meter/ 

http://arduinoarts.com/2011/08/uv-meter/

 
Zircon - This is a contributing Drupal Theme
WeebPal